Tec 2000 Engine Flush 2.5l

tec 2000 engine flush is used during a regular oil change but its effects go far beyond standard cleaning fluids. To fully benefit from its potential it's worth following a few simple steps.start by warming up the engine – it should reach operating temperature (approx. 60°c). Then add the contents of one can of flush (375 ml per 4-5 liters of oil) to the old oil. Start the engine and let it idle for 10-15 minutes. If the engine exhibits symptoms such as smoking oil consumption or rough running you can extend the application time to 25-30 minutes.after this step simply drain the old oil replace the filter and add fresh engine oil. The process is completely safe for the engine and all its components and the effects are usually felt after the first use.instructionswarm up the engineuntil the coolant temperature reaches ~60?cstop the engineunscrew the oil filler cap and pour the preparation into the engine375 ml per 4-5 liters of engine oilclose the oil filler capstart the engine and let it idle for ~15 minutesnote 1: leave the car on a private property or in a well-ventilated room. note 2: if you suspect that there is a large amount of carbon deposits in the engine the engine exhibits increased smoke consumes more than 1 liter of oil per 1000 km the flushing process can be extended.stop the engine unscrew the oil filter drain the used oil with the flushing solution.install a new oil filter and fill the engine oil to the proper level.run the engine for about 30 seconds turn off the engine then check the oil level and top it up to the proper level.**